“The Effect of Fly-ash on Morphological Characterization of Fly-Ash Based Polymer Composites”

Authors

  • Dr. Samiksha Tiwari

Keywords:

FTIR, XRD, PS, FA

Abstract

In this study the effect of fly-ash on structure and surface morphology of different type of fly ash reinforced polystyrene composites have been investigated .XRD analysis is reported the crystalline index increases with increasing the concentration of the fly ash. FTIR spectra of pure polystyrene pure fly ash and fly ash based composites have been observed and analyzed. The shifting of parent peaks were observed in composite films. The shifting may come from the results of physical bonding between polystyrene and fly ash.

References

Abdullah MA, Altaweelmohamad, Ranganathaiah C. & Siddramaiah B. (2016)

Positron Life time spectroscopy and differential scanning colorimetric study of

polystyrene based composites with flyash, cenospheres, and calcium aluminosilicate

as fillers. Journal of applied polymer science, Vol. 116, 3087-3094.

Bajpai R, Datt SC (2015) Effect of load on microhardness of polycarbonate. Indian J

pure Applphys 24(5); 254-255.

Chauhan S.R., Kumar Anoop Singh and Kumar Prashant , (2014) Effect of flyash

content on friction and dry sliding wear behavior of Glass fiber reinforced polymer

composites – A Taguchi Approach. Journal of minerals & Materials Characterization

& Engineering, Vol. 9, No. 4, pp. 365-387.

CelikOzlem, DamliErdem&DiskimSabriya (2013) Characterization of flyash and it

effects on the compressive strength properties of portland cement. Indian Journal of

engineering & materials sciences Vol. 15, pp 433-440.

Dubey PK, Bajpai R, Keller JM (2012) Structural, morphological and microhardness

characterization in polymer complex of laser dye rhodamine (Rh6G) doped

polymethylmethacoylate. MicrosystTechnol14 ; 1165-1171.

Fernandez –Jeinenez A, and Palmo A (2011) Composition and microstructure of

alkali activated flyashbinder : Effect of the activator. Science direct cement and

concrete research 35, 1984-1992Kishore. Kulkarni SM, Sharathchadra S, Sunil D

(2008) on the use of an instrumented set-up to characterize the impact behaviour of an

epoxy system containing varying flyash content. Polymer testing 21, pp 763-771.

Patel Arunendra Kumar, Bajpai R, Keller JM, KumariBindu, vatsal V, &Saha A

(2006) Structural, morphological and micromechanical studies on flyash reinforced

PMMA composites. MicrosystTechnol, Do I 10.1007/ s 00542-011-1356-1.

Ramrakhiani M, Parashar P, Dutt SC (2005) Study of the degree of crystallinity in

eudragit/ poly (methyl methacrylate ) poly blends by X-ray diffraction. J Applpolym

Sci. 96; 1835-1838

Downloads

Published

2018-11-30

Issue

Vol. 7 No. 12 (2018): NOVEMBER 2018

Section

Articles

License

Copyright Notice

Submission of an article implies that the work described has not been published previously (except in the form of an abstract or as part of a published lecture or academic thesis), that it is not under consideration for publication elsewhere, that its publication is approved by all authors and tacitly or explicitly by the responsible authorities where the work was carried out, and that, if accepted, will not be published elsewhere in the same form, in English or in any other language, without the written consent of the Publisher. The Editors reserve the right to edit or otherwise alter all contributions, but authors will receive proofs for approval before publication.

Copyrights for articles published in World Scholars journals are retained by the authors, with first publication rights granted to the journal. The journal/publisher is not responsible for subsequent uses of the work. It is the author's responsibility to bring an infringement action if so desired by the author.